The advice is to ensure your HDX card(s) have been connected to the internal power of your computer or chassis, and that the fans are working properly. The advice is to ensure that your interfaces are powered on and that all DigiLink cables are secured on both ends.ĪAE Errors 11 are warnings that one of your HDX cards is overheating With an AAE Error -1178, this is a warning that the HDX card fan is not spinning.
Error 6001 pro tools interface pro#
If there are failures, try moving the HDX card to another PCIe slot and run the utility again.ĪAE Error -1177 will pop up if you do not have an audio interface connected to an HDX card when you launch Pro Tools. If the error persists, run the DigiTest utility to verify if there are any failures. Shut down the computer and power cycle the chassis (if applicable). We have grouped these 3 error messages together as they all relate to Pro Tools HDX cards.ĪAE Error -1174 can pop up when you are using an HDX card in an expansion chassis.
Error 6001 pro tools interface install#
Once you have identified the culprit then go and get the latest version and install it and all should be good. I’m smart enough to realise that if you have 7 plug-ins then you can do it in less than 8 moves. I am reliably informed, but not smart enough to do the maths, that irrespective of the number of plug-ins you have, that you should find the culprit in around 8 moves - not of course accounting for those with low plug-in counts. If it does, then divide the remaining group in half again and repeat the process until you find the culprit. If it does, then pull them back out and try the other half - it should crash. Drag one half of that group back to your plug-in folder and see if your system launches There is no shortcut to figuring out which plug-in may be crashing your system, this is how you do it.Ĭreate a folder on your desktop (or somewhere safe) and then drag all the plug-ins from your plug-ins folder to the new folder for safe-keeping. Note that an incompatible plugin can cause problems just being in your plugins folder, it doesn’t have to be used in the session, just being in the plugin folder is enough to be a problem. It would appear that the main reason for an AAE Erro -55, is an incompatible plugin. However, note that we did add a caveat regarding illegal characters.īasically the safest thing to do is not to use * | " : ? / \ when naming anything!ĪAE Error 55 can pop up when launching Pro Tools. For more details check out our article You Can Use Emojis And Symbols In Pro Tools Sessions - Here's How. We did discover that you can use Emojis and Symbols. Apparently, they may be used when naming playlists but be aware that they will be replaced by an underscore (_) if they make their way to an audio file name via recording, bouncing, consolidating, etc.Īs a consequence, it is recommended that you try and avoid using these characters when naming sessions and playlists in Pro Tools.Īlso, avoid using these illegal characters in external hard drives and networked volume names, naming drives and folders as well as using forward / and back \ slashes and connecting external drives sharing the same exact name. These should not be used in session or project names or media names.
It can be the same issue as Error 2 in that you could have 2 drives with the same name, but AAE Error -35 is more likely to occur because one of your drives has one or more macOS illegal characters in the name. This usually pops up when launching or opening a session with Pro Tools on a macOS Pro Tools system. Along similar lines, as AAE Error 2, there is AAE Error -35.
0 kommentar(er)
